|
General Rules for Replacing
Tires
Replacement tires must have:
- load carrying ability equal to or greater
than required by vehicle placard
- inflation pressure capability equal to or
greater then the pressure specified by manufacturer
Tire Mixing
- it is preferred that all 4 tires be the
same size, speed rating, and construction (radial or bias)
- match tire size designations in pairs on an
axle, except for temporary use of a spare tire
- if 2 radial and 2 non-radial tires are
used, put the radials on the rear axle
- snow tires should be applied in pairs to
the drive axle (front or rear) or to all 4 positions
- when studded snow tires are mounted on the
front, they also must be mounted on the rear
- match tire sizes and constructions on
4-wheel drive vehicles
Rim and Wheel Selection
- mount tires only on approved rim widths
- always check to be certain that the
diameter designation for both tire and rim are the same. For example:
a P225/75R15 tire must be mounted on a 15" rim
|